Add one capacitor to each LED or HID bulb which is flickering. Plug'n'Play cable fits 9005 9006 9012 H10 bulb connectors.
Tested on:
- 2006 Lexus IS350 high beam/DRL LED headlight bulbs. LED bulb flickered in DRL and these capacitors fixed the flickering issue.
- 2014 Jeep Wrangler - LED fog lights stopped flickering after installing these capacitors.
Note:
- These will NOT fix a problem with lights shutting off due to low power consumption of LEDs or HIDs - you need resistors for that or higher Amperage LED kits.
- These will also not fix 100% of flickering issues caused by DRL pulse width modulation in the late model vehicles - your may need to get the latest anti-flicker decoders for that.
Installation:
- HID bulbs - connect to factory headlight harness and then to HID ballast.
- LED bulbs - connect to factory headlight harness and then to LED bulb (for all-in-one bulbs) or LED driver (for high power LED kits)
1 year
1 Review Hide Reviews Show Reviews
-
Did not work on my Hyundai
1. Bought these because the hid lights (bought on a different site) were turning off as soon as the engine is running. After adding these the problem persists. REPLY: This product cancels dash lamp-out warning lights, and stops LED or HIDs from flickering (strobing). If your lights are shutting off completely after the engine is started then you will need to use resistors. 2. Also no instructions and you have to assume the red wire is the +12 volt side. REPLY: There is only one way these can be connected because each connector has only one side with a clip.
