These H11B X10 fan-cooled LED bulbs are a true plug-n-play replacement for H11B halogen bulbs. They plug directly into the existing headlight power connector. No extra LED drivers to worry about because these bulbs have built-in LED drivers. 100% plug-n-play. Install time is usually just a few minutes.
Kit includes: 2x H11B LED bulbs.
FITMENT:
- H11B LED is only 5mm longer than a halogen H11B, so you will need to have a minimum of 5mm (0.5cm or 0.2 inch) of extra space under the dust cap to fit these in. Most manufacturers allow for this extra space in their headlight design. We have not found a vehicle yet which would not allow the dust caps to be re-installed after installing these H11B LED bulbs.
- Please check out photos 5-7
FEATURES:
- LED chips on both sides of the bulb are ON providing 360 degree light source
- Adjustable beam: No
- Brightness: 6000lm per bulb, 12000lm per kit
- Power: 30W per bulb, 60W per kit
- Measured power draw: 2.6A@12V (halogen bulb draws 4.89A@12V)
- LED Color Temperature: 6000K
- Voltage: DC 9-32V
- 6V DRL compatible: NO (lowest operating voltage is 8.0V)
- Built-in canbus: Yes
- Lifespan: 50,000+hrs
- Rating: IP67
- Working temperature: -45C to +85C
- Cooling: fan-cooled
- Plug-n-Play: YES
DIMENSIONS:
Total bulb length: 7.4cm
Bulb length from base to top: 5.0cm
Fan diameter: 3.0cm
Fan body length: 2.4cm
FITS:
- KIA vehicles with H11B bulbs
- HYUNDAI vehicles with H11B bulbs
- 2011 Hyundai SantaFe
- 2013 Ford Fiesta
THE KIT IS NOT PLUG-N-PLAY FOR THIS VEHICLE:
- 2014 Hyundai SantaFe - the bulb fits perfectly, but the connector pins on the bulb do NOT align with the headlight connector slots. There is about a 3mm difference in alignment. To make it work, the OE headlight connectors would have to be removed from the base and then connected to the LED. It's a bit of extra work but it can be done. If you're considering doing it then you might as well upgrade to another H11 LED kit with more light output.
2 Reviews Hide Reviews Show Reviews
-
2013 Ford Fiesta
Fiestas are notorious for their need to remove the headlight to install the low beam bulb, and the bulbs are not easy to come by. The bulbs were delivered quickly and had two different o-rings on them. At first, I did not understand the reasons behind it, but then I figured out that the bulb fit was different between the driver and passenger sides (the driver side needed a smaller ring for a proper fit.) Kudos to the nice folks at HVC that paid attention to such a small detail. The bulbs are bright, no flicker (I did not test the DRLs, I have that disabled,) and the shipping was fast. 5 stars. P.S. The dust cap fit is very tight with these bulbs. I had to use a flat screwdriver to jam the dustcap between the fan and the side of the opening on the housing. It is a bit of a hassle, but doable. P.P.S. Make sure to check the headlight adjustment after install. My low beam was way too low.
-
Install and preformance
First the not so good. Plug an play was not quite accurate on my Veloster Turbo a little manipulation was required. Now the good light output is great the beam is very tight. The only issue is when I first turn them on passenger side flickers for a moment but then is fine. Definitely worth buying though! Thanks Vision Canada.
