Jeep Wrangler Spare Tire Dynamic RGB LED Wheel Light + Brake Light

CAD $109.00
(No reviews yet) Write a Review
SKU:
SKU-1548
Availability:
in stock
Shipping:
Calculated at Checkout
Adding to cart… The item has been added

Jeep Wrangler Spare Tire RGB LED Wheel Light + Brake Light adds more braking visibility to your Jeep and gives it a bit customization via user selectable LED colors.

SPECIFICATIONS

  • LED count: 85 RGB LEDs
  • Controller: Remote (included)
  • IP67 waterproof
  • RGB lights can be turned on/off via remote and provide special light effects or single user selected color
  • Connecting the brake wire overrides the RGB color selection and turns the ring RED when braking 
  • 20 RGB dynamic light modes
  • Red brake light

DIMENSIONS:

  • Total wire length from the wheel ring to the end of the bare wires - 230cm (126") 
  • Wire length from the wheel ring to the control box - 190cm (74")
  • Wheel ring diameter - 35cm (13.75")
  • Wheel ring depth - 2cm (0.75")

WIRING - red, black, white

  • Connect RED wire (+) to the BLUE wire (+) on the OEM connector
  • Connect the BLACK wire (-) to the PURPLE wire on the OEM connector
  • Brake light - Connect WHITE wire (+) to a GREEN brake light (+) wire on the OEM connector

INSTALLATION:

  • DIY time: 1.5hrs.
  • Remove the spare tire and install the RGB LED ring on the spare tire mount on the tailgate.
  • Remove the inside tailgate panel - There are 14 tabs on the inside of the panel that will need to be popped out before the panel can be removed. Use a panel remover tool.
  • Run the wires through the spare wire harness hole in the tailgate. It is located on the right side of the spare tire mount.
  • Remove the passenger side taillight. There is a small access cover on the inside of the Jeep that needs to be removed. Under it, you will find a 10mm plastic bolt which will unlock the tailight.
  • Remove the plastic cover on the passenger inside of the Jeep that covers when wheel well. 
  • Connect the red (+), black (negative), and white (brake) wires to the passenger side taillight black. See the wiring diagram image.
  • Mount the control box on the passenger side under the fender cover.
  • Test the light functionality - brake and RGB using the remote.
  • Re-install the taillight, the tailgate inside panel, and the spare tire

 

1 year